B&K Precision 9171-9174 - Manual - Manual (Page 68)

56
Note: When multiple output control is setup, there will be a maximum of 3
ms delay between channel 1 and channel 2 when both channels change
output from OFF (disable) state to ON (enable) state.
Follow the steps below to configure this setting:
1. Press , then to enter SYSTEM SETTING. Go
down the list of settings and select OUTPUT MODE.
2. Press to select MULTI. Press to confirm the
changes, and press twice to exit the menu. If SINGLE
is selected, output control of the two channels will not be
simultaneous; their output states can be controlled
independently.
Series/Parallel Tracking Mode
Tracking mode can be enabled so that both channels can be
synchronized, especially when connected together in series or
parallel. To turn on tracking mode, follow the steps here:
1. Press , then to enter SYSTEM SETTING. Go
down the list of settings and select TRACKING MODE.
2. Press to select ON. Press to confirm the changes,
and press twice to exit the menu. To disable it, select
OFF.
Enter
Esc
Menu 1
Enter
Esc
Menu 1