B&K Precision 9171-9174 - Manual - Manual (Page 120)

108
PROGram:CLEar:ALL
Description: Clears all programmed sequences stored in all 10
program locations.
Syntax: PROGram:CLEar:ALL
Example: PROG:CLE:ALL
Clears all the programmed sequences in all 10 program
locations.
PROGram:NEXT
Description: Configures/Queries the next program location’s
sequence to run.
Syntax: PROGram:NEXT
PROGram:NEXT?
- 1 – 10 are valid program locations. Use 0
to end if no further sequences will be run after the
current sequence.
Example: PROG:NEXT 5
Runs the set of sequences in program location 5 after
the current sequence is finished.
Query: PROG:NEXT?
Return String: 3
Currently configured to run sequence in program
location 3 after current sequence ends.
Format:
PROGram:REPeat
Description: Configures/Queries the number of times to repeat the
selected programmed sequence.
Syntax: PROGram:REPeat
PROGram:REPeat?
- 1 – 50000 (max.)
Example: PROG:REP 10
Runs the set of sequences in the selected program
location 10 times.
Query: PROG:REP?
Return String: 300
Currently set to repeat the sequence 300 times.
Format: