B&K Precision 9171-9174 - Manual - Manual (Page 45)

33
2. Install the USB driver. Visit www.bkprecision.com to
download the driver. Run the setup executable after
unzipping the downloaded file.
Note: Do this before connecting the USB cable from the
power supply to the PC.
3. Once the installation is successful, connect the USB cable
between the power supply and the PC. Drivers should be
automatically recognized. To verify, go to “Device Manager”
in Windows, and under “Ports (COM & LPT)”, a new device
listed as “210x USB to UART Bridge (COM#)” will be listed.
The “#” is the COM port number assigned by your computer
to interface with the instrument via USB virtual COM.
4. The serial (virtual COM) settings to use are:
BAUDRATE: 57600
PARITY: NONE
DATA BITS: 8
STOP BIT: 1
FLOW CONTROL: NONE