B&K Precision 9171-9174 - Manual - Manual (Page 146)

134
4.3 Sequence Programming
The power supply has the ability to store custom programmed
sequences and run them, as described in “3.11Sequence Program
Mode”. This section provides some examples of how to create
some sequences using remote commands described in the previous
section.
Examples
Example 1:
To create an output sequence like above, send the following list of
commands in order:
PROG 1 Choose program number
PROG:CLE Clear program 1 data
PROG:REP 0 No repeat (repeat one time for “1”)
PROG:TOTA 8 Set program 1 to have 8 steps in total
PROG:STEP 1 Following 3 settings are for step 1
PROG:STEP:CURR 1 Set output current to 1 ampere