B&K Precision 9171-9174 - Manual - Manual (Page 57)

45
Configure Voltage and Current Output
Voltage and current can be set and output from the front panel and
the rear panel terminals. Refer to “3.7 Remote Sense” for setup
instructions if remote sense will be used for voltage compensation at
the output.
Setting Voltage
Follow the steps below to set the output voltage:
1. For single channel models, skip to step 2 below. For dual
channel models, from the main display press or
to select the channel for setting voltage. The channel
indicators CH1 or CH2 will flash to indicate the selected
channel.
2. With the main display shown, press and use the numeric
keypad to enter your set voltage. Then press . Below is
an example screen for setting 5 V.
CH1 CURR LIMIT MAX = _10.200 A
CH1 CURR LIMIT MIN= 0.000 A
CH2 CURR LIMIT MAX = _10.200 A
CH2 CURR LIMIT MIN = _ 0.000 A
Vset
Enter