B&K Precision 9171-9174 - Manual - Manual (Page 47)

35
3. If STATIC is selected, then select IP ADDRESS and use the
numerical keypad to enter the static IP. After entering each
group of 3 digits, press to go to the next group. The
cursor will automatically move to the next group. Do this until
all 12 digits are entered. Be sure to press one more
time after entering the last 3 digits for the complete IP
address entry to be saved.
RS-232 and RS-485 Interface (Optional)
Both RS-232 and RS-485 interface are supported by the power
supply through an optional RS-232 or RS-485 interface card. Both
of these card options must be properly installed before they can be
used. See “1.7 Installing Optional Interface Cards” for details.
RS-232 Interface
The setup for remote control via RS-232 interface is very similar to
the same for USB virtual COM interface. To setup the power supply
for RS-232 operation:
1. Press , then to enter SYSTEM SETTING. Select
REMOTE and press or until “ RS232” is displayed.
Press to save changes.
2. The settings used for RS232 communication are:
Enter
Menu 1
Enter
Enter