B&K Precision 9171-9174 - Manual - Manual (Page 55)

43
3.5 Configure Voltage and Current Output
Voltage and Current Limit Settings
The power supply has software voltage and current limit protection
settings that can be configured to limit the settable range for output
from front panel or remote operation. Follow the steps in this section
to adjust these settings.
Voltage Limit Set
1. Press , then to enter OUTPUT SETTING. Press
to select VOLT LIMIT SETTING.
2. VOLT LIMIT MAX should be selected. Use the keypad to
enter the maximum voltage set limit and press to save
changes. The maximum voltage that can be set depends on
the power supply’s maximum output voltage.
3. VOLT LIMIT MIN is now selected. Again, use the keypad to
enter the minimum voltage set limit and press to save
changes.
4. Press once to return to previous menu items, or press
three times to exit the menu when finished.
Dual Channel Models
For models with dual channels, the display will look different, with
CH1 and CH2 indicators on the left side of the display to indicate
their respective VOLT LIMIT MAX/MIN parameters.
Menu 2 1
Enter
Enter
Esc