B&K Precision 9171-9174 - Manual - Manual (Page 37)

25
Output Check
Voltage Check
Follow the steps below to check basic voltage output with no load
connected.
1. Turn on the power supply. The display will show the OFF
annunciator next to the setting voltage on the left side of the
display.
2. Enable the output by pressing (or and for
dual channel models). The output indicator light will be lit
and display will show the measured output voltage. The
OFF annunciator will change to CV.
3. Using the numeric keypad, press and enter a voltage
value. Then press the key. For dual channel models,
select the channel first before setting the voltage. The
selected channel is indicated by a flashing CH1 or CH2
annunciator on the display. Press
or to select
the channel.
4. The measured output voltage should change to a value close
to or exactly what you entered (For example, if voltage value
is 30.000 V, it may show 29.998 V).
5. (Optional) You may also verify the output voltage by
connecting either the (+) and (-) terminals on the front panel
or the rear panel to an external voltmeter. The measured
value should match or be close to the entered voltage value.
Vset
Enter
OUTPUT CH1 CH2