B&K Precision 9171-9174 - Manual - Manual (Page 103)

91
Parameter Definitions
Unless otherwise noted, the following table of parameter definitions
applies to all supported remote commands. Commands that have [ ]
around them are optional. For example, [SOURce] is not required
for the SOURCE subsystem.
Table 8- Parameter Definitions
Parameter Description
“ON” or “1”, “OFF” or 0
Data format for integers. Zero, positive, and
negative integer numeric values are valid data.
Data format for floating numeric representation.
Zero, positive, and negative floating point numeric
values are all valid data.
Line feed character (0x0A) used for termination of
a string
Carriage return character (0x0D))used for
termination of a string
Space character
Remote Commands
All commands are terminated with both a and or just
character. For example, to query the instrument’s ID, this
command is sent:
*IDN?
*IDN?
Commands sent without correct termination will return an error
and/or will not have a response.
All commands listed in this