B&K Precision 9171-9174 - Manual - Manual (Page 151)

139
communicate with each connected instrument with this specific
setup.
Remote Commands via USB
The following lists all the available commands to control multiple
power supplies with the multi unit programming configuration
illustrated in “Figure 30”. For all configuration commands (except for
commands listed under
Synchronous Control Commandssection),
the instrument will return a string “ OK” to indicate command sent
successfully. If an error occurs, it will return an error. See the “Error
List” section for details.
System Control Command
This set of commands is used to select the instrument (based on
their address) to control and to obtain/set its system settings.
CADR
CCLS
CRST
CIDN?
CREV
CSN?
CST?
CCLR