EVS IPDirector Version 6.0 - November 2012 Part 8 User's Manual - Manual (Page 202)

4. Do one of the following to define a swap or mute:
◦ For a swap, click in the matrix at the intersection between the source channel to
play and the output channel on which the source should be played.
◦ For a mute, click in the matrix on the bullet located on the line of the output
channel to mute.
5. If you want to apply the swap between a mark IN and mark OUT points, tick the
Apply between mark IN and mark OUT check box.
In this case, you can overwrite existing swap/mute between these points by ticking
the Overwrite existing swap/mute check box.
6. If you want to define a mix effect at the start and end of the swap, specify the duration
of the effect in the Swap mix duration spin box.
7. Click Apply.
The swap and mutes are defined on the requested part of the audio track.
This is symbolized with the swap icon or the mute icon displayed on the relevant
elements in the general display of the timeline.
The swaps and mutes can be viewed on the Swap/Mute Zoom display:
190 6. Timeline
EVS Broadcast Equipment S.A. - November 2012 Issue 6.00.A