How to slip an element using the shuttlepro – EVS IPDirector Version 6.0 - November 2012 Part 8 User's Manual User Manual
Page 160

2. Click the keyboard shortcuts
,
,
,
and/or
to select or
unselect the tracks you want or do not want to slip.
3. Use the following keyboard shortcuts to perform the slide action:
◦
to slip the element 10 frames to the left.
◦
to slip the element 1 frame to the left.
◦
to slip the element 1 frame to the right.
◦
to slip the element 10 frames to the right.
When you release the key, the slip action is applied within 1 sec.
4. Click anywhere in the Lasso Selection area to leave the slip mode.
6.10.5. How to Slip an Element Using the ShuttlePRO
To slip one or more elements of the same source media using the ShuttlePRO, proceed
as follows:
1. Activate the slip mode on the requested elements by lassoing the whole elements
from right to left. See section "Activating and Deactivating the Slip Mode" on page
145.
->
2. Click the requested Timeline Track Selection buttons to select or unselect the
tracks you want or do not want to slip.
3. Rotate the jog to the left or to the right to slide the elements respectively to the left or
to the right.
When you stop turning the jog, the slip action is applied within 1 sec.
4. Click anywhere in the Lasso Selection area to leave the slip mode.
148
6. Timeline
EVS Broadcast Equipment S.A. - November 2012
Issue 6.00.A