EVS IPDirector Version 6.0 - November 2012 Part 8 User's Manual - Manual (Page 200)

Note
If an audio transition effect is defined where the swap mix is defined, the
transition effect will have priority on the swap mix. The latter will not be applied.
6.13.8. Adding Audio Swaps
How to Add a Swap or Mute to one or More Elements
of an Audio Track
To add an audio swap to one or more elements of an audio track, proceed as follows:
1. In the general timeline display, select the elements of a track on which you want to
define a swap. For a multiple selection, select the elements while pressing CTRL.
2. Right-click one of the selected elements and select Add Swap/Mute.
The Swap/Mute Configuration window opens:
3. Do one of the following to define a swap or mute:
◦ For a swap, click in the matrix at the intersection between the source channel to
play and the output channel on which the source should be played.
◦ For a mute, click in the matrix on the bullet located on the line of the output
channel to mute.
4. Repeat the step 3 on all the channels that you want to swap or mute.
5. Click Apply.
188 6. Timeline
EVS Broadcast Equipment S.A. - November 2012 Issue 6.00.A