Nortel Networks NN43001-301 - Manual (Page 95)

95
MSDL installation for all systems
Contents
The section contains information on the following topics:
"Install the MSDL" (page 95)
"Replace the MSDL" (page 98)
Install the MSDL
Installation procedures for the MSDL card are the same for Large Systems.
Use
Procedure 9 "Install the MSDL card" (page 95) below. See Figure 40
"MSDL card layout" (page 97) , and Table 28 "MSDL switch settings" (page
97) for the port and interface switch settings.
The MSDL card goes into the following slots:
Half Group,
Single Group CPU/Network Module slot 1–8, 13
Multi Group Network Module slot 5–14
Refer to Software Input Output Reference — System Messages
(NN43001-712) and Circuit Card Reference (NN43001-311) for more
information.
Procedure 9
Install the MSDL card
Step Action
1 Determine module and slot location for the MSDL card. Unpack and
inspect the MSDL card.
2 Set the MSDL switch settings to correspond to Table 28 "MSDL
switch settings" (page 97) , and Figure 40 "MSDL card layout" (page
97) .
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301 02.03 Standard
Release 5.5 7 December 2007
Copyright © 2003-2007, Nortel Networks
.