Nortel Networks NN43001-301 User Manual
Page 248
248
2.0 Mb DTI implementation
Prompt
Response
Description
ONP
r
t
On-premises extension.
OPX
r
t
Off-premises extension.
TNLS
YES (NO)
TN List. This is for the print command only.
A YES response means that a list of the trunk TNs using the
requested PAD category tables are printed after the table.
DFLT
(1)-16
For NEW only. The table is used for default values.
The following prompts define the pad levels.
The receiving pad code is r and the transmission pad code is t. These entries have the range 0-15.
The pad values (in decibels) relating to these codes are shown after this table.
ONP
r
t
On-premises extension.
OPX
r
t
Off-premises extension.
DTT
r
t
Digital TIE trunks.
SDTT
r
t
Digital Satellite TIE trunks.
NTC
r
t
Nontransmission compensated.
TRC
r
t
Transmission compensated.
DCO
r
t
digital COT, FEX, WAT, and DID trunks.
VNL
r
t
Via Net Loss.
DTO
r
t
2.0 Mb DTI digital TOLL office trunks.
ACO
r
t
Analog CO or WATS trunks.
AFX
r
t
Analog FEX trunks.
ADD
r
t
Analog DID trunks.
SATT
r
t
Analog satellite TIE trunks.
ATO
r
t
Analog TOLL office trunks.
DTI2
r
t
2.0 Mb DTI trunk
(Prompted only if the 1.5/2.0 Mb Gateway feature is equipped
and TYPE=DTI2).
XUT
r
t
Analog CO trunk
(Prompted only if the 1.5/2.0 Mb Gateway feature is equipped
and TYPE=DTI2).
XEM
r
t
Analog TIE trunk
(Prompted only if the 1.5/2.0 Mb Gateway feature is equipped
and TYPE=DTI2).
The following pads are available for the 2.0 Mb DTI card. Their respective
codes are also given. Positive dB represents loss and negative dB
represents gain.
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301
02.03
Standard
Release 5.5
7 December 2007
Copyright © 2003-2007, Nortel Networks
.