Nortel Networks NN43001-301 - Manual (Page 247)

DTI software implementation 247
Prompt Response Description
PDCA 1-16 PAD Category table.
If one channel is using the specified table, then the command
is aborted.
Cannot modify or delete Table 1.
TNLS YES (NO) TN List. This is for the print command only.
A YES response means that a list of the trunk TNs using the
requested PAD category tables are printed after the table.
DFLT (1)-16 For NEW only. The table is used for default values.
The following prompts define the pad levels.
The receiving pad code is r and the transmission pad code is t. These entries have the range 0-15.
The pad values (in decibels) relating to these codes are shown after this table.
ONP r t On-premises extension.
OPX r t Off-premises extension.
DTT r t Digital TIE trunks.
SDTT r t Digital Satellite TIE trunks.
NTC r t Nontransmission compensated.
TRC r t Transmission compensated.
DCO r t Digital COT, FEX, WAT, and DID trunks.
VNL r t Via Net Loss.
DTO r t 2.0 Mb DTI digital TOLL office trunks.
ACO r t AnalogCO or WATS trunks.
AFX r t Analog FEX trunks.
ADD r t Analog DID trunks.
SATT r t Analog satellite TIE trunks.
TNLS YES (NO) TN List. This is for the print command only.
A YES response means that a list of the trunk TNs using the
requested PAD category tables are printed after the table.
DFLT (1)-16 For NEW only. The table is used for default values.
The following prompts define the pad levels.
The receiving pad code is r and the transmission pad code is t. These entries have the range 0-15.
The pad values (in decibels) relating to these codes are shown after this table.
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301 02.03 Standard
Release 5.5 7 December 2007
Copyright © 2003-2007, Nortel Networks
.