Table 24 port 0 mode selection, Figure 37 – Nortel Networks NN43001-301 User Manual
Page 83

Set up the NT6D11AB, NT6D11AE, NT6D11AF DCHI
83
Figure 37
NT6D11 DCH with ISL low-speed programming jumper settings
Port addressing modes
Port 0 Mode selection
Port 0 is used to select whether the asynchronous ESDI port is be disabled
or not. Refer to
Table 24 "Port 0 mode selection" (page 83)
Note: The asynchronous ESDI port must be set to "disabled".
Table 24
Port 0 mode selection
Port Mode
Switch Setting
SW1.1
SW1.2
Not used
0
-
Asynchronous ESDI
1
0
Port disabled
1
1
Port 1 mode selection
Port 1 is used to select the standard or expanded D-channel addressing
mode on the NT6D11AB/AE/AF. Refer to
Table 25 "Port 1 mode selection"
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301
02.03
Standard
Release 5.5
7 December 2007
Copyright © 2003-2007, Nortel Networks
.