Nortel Networks NN43001-301 - Manual (Page 215)

Install PRI hardware 215
Prompt Response Description
Special Number.
Location Code
ISDN YES Customer is equipped with ISDN.
- PNI (0) 1-32700 Private Network Identifier. Each customer data block must
have a unique PNI when multi-customer option is equipped.
PNI = 1 is typical for CUST = 0. It must be matched by
the PNI in the far-end RDB.
Note: Using the default value of PNI = 0 prevents operation
of features like NRAG, NACD and NMS.
- HNPA NPA Telephone area code for this system. Sent as part of setup
message as calling line identification.
- HNXX NXX Telephone local exchange code for this system. Sent as
part of setup message as calling line identification.
- - HLOC XXX Home location code (NARS), prompted when PRA = YES.
- - LSC 1-9999 One to four digit Local Steering Code, if required in the
Coordinated Dialing Plan (CDP). LSCs are required only if
the CDP DNs are longer than the local PDNs.
The CLID sent for a CDP call is composed of the LSC
defined in LD 15 plus the PDN of the calling set. Various
ISDN network features depend on the CLID as the "return
address" for sending feature control messages.
Multiple LSCs can be defined in LD 87 for CDP, but only
one LSC can be defined here for CLID.
LD 16 - Configuring an ISDN service route
Prompt Response Description
REQ NEW
CHG Add new data.
Change existing data.
TYPE RDB Route data block.
TKTP xxx Trunk type.
DTRK YES Digital trunk route.
- DGTP PRI 1.5 Mb PRI. Prompted only if PRA = YES in LD15.
ISDN YES ISDN option.
- MODE PRA Route used for PRA only.
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301 02.03 Standard
Release 5.5 7 December 2007
Copyright © 2003-2007, Nortel Networks
.