Nortel Networks NN43001-301 - Manual (Page 243)

DTI software implementation 243
Prompt Response Description
SEZ(R) abcd Seize signal (send or receive) for voice or data calls from or
to a non-SL-1.
SEZD(R) abcd Seize signal (send or receive) for data calls between SL-1s.
N If SEZD(R) signal not required.
SEZV(R) abcd Seize signal (send or receive) for voice calls.
N If SEZV(R) signals not required.
P CALL(R) abcd (Receive) signal sent during seize by an incoming CO trunk.
TIME ON OFF Length of pulse time on, and time off.
(default 2 seconds on, 8 seconds off)
SEZA(S) abcd Seize signal acknowledgment (send).
N If SEZA(S) signal not required.
P WNKS(S) abcd Wink start (corresponds to a pulsed seize acknowledgment).
Prompted when SEZA(S) not required.
N If WNKS(S) signal not required.
TIME 10-(220)-630 Time for WNKS(S) signal in milliseconds.
P DIGT(R) abcd (Receive) decadic pulses.
N If DIGT(R) not required.
NRCV(S) abcd Number received signal (send).
N If NRCV(S) signal not required.
P EOSF(S) abcd End of selection free (send).
N If EOSF(S) not required.
TIME (100)-150 Time for EOSF(S) in milliseconds.
P EOSB(S) abcd End of selection busy (send).
N If EOSB(S) not required.
TIME (100)-150 Time for EOSB(S) in milliseconds.
P OPCA(R) abcd Operator calling time (receive) signal.
N If OPCA(R) not required.
TIME 64-(128)-192 Time of OPCA(R) pulse in milliseconds.
REPT (1)-5 Number of OPCA(R) pulses.
CONN(S) abcd Connect send.
CONN(R) abcd Connect receive.
P RRC(S) abcd Register recall (send) signal. Activated by Malicious Call Trace.
N If RRC(S) not required.
TIME 10-(100)-150 Time of RRC(S) signal in milliseconds.
P BURS(S) abcd Bring up receiver (send). Uses switchhook flash timer for timer.
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301 02.03 Standard
Release 5.5 7 December 2007
Copyright © 2003-2007, Nortel Networks
.