Nortel Networks NN43001-301 - Manual (Page 235)

Basic ISL implementation 235
Prompt Response Description
AC2 Access Code 2. Enter call types (type of number) that use
access code 2. Multiple responses are permitted. This
prompt only appears on NARS equipped systems. If a call
type is not entered here, it is automatically defaulted to
access code 1.
NPA E.164 National.
NXX E.164 Subscriber.
INTL International.
SPN Special Number.
LOC Location Code.
LD 16 - Enabling ISL option on a per-route basis, assigning a D-channel for each route
Prompt Response Description
REQ NEW CHG Add new data. Change existing data.
TYPE RDB Route data block.
CUST xx Customer number as defined in LD 15.
ROUT 0-511 Route number Range for Large System and CS 1000E
system.
0-127 Range for Meridian 1 Small System, Media Gateway 1000B
TKTP TIE TIE Trunk route.
DTRK YES/NO Enter YES if this is a Digital Trunk Interface (DTI or PRI).
ISDN YES ISDN option.
MODE ISLD Route for ISL application.
DCHI XX DCHI port number in CFN which carries the D-channel for
this TIE Trunk route.
PNI 1-32700 Customer private network identifier. Must be the same as
the CDB PNI at the far-end.
IFC Interface type.
SL1 Interface type
CTYP Call Type. Enter the call type to be associated with the
outgoing route for direct dialing using the trunk access code
(instead of NARS access code). See the Software Input
Output Reference — System Messages (NN43001-712)
for a list of valid responses.
INAC YES Insert Access Code. Permits the NARS AC1 or AC2
access code to be reinserted automatically on an incoming
ESN call.
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301 02.03 Standard
Release 5.5 7 December 2007
Copyright © 2003-2007, Nortel Networks
.