Nortel Networks NN43001-301 - Manual (Page 222)

222 1.5 Mb DTI implementation
Software enable the DTI/PRI cards
Procedure 34
Enabling the NTRB21 TMDI card
Step Action
1 Enter the following command in LD 96 to enable the NTRB21 TMDI
card:
ENL TMDI x ALL
where
x is the NTRB21 TMDI card number (DLOP). The card number
associated with a NTRB21 TMDI card is based on the slot in
which the card is installed.
2 If in DTI mode, enter the following command in LD 96 to software
enable the D-channel:
ENL DCH y
where
y is the DCH port number that was assigned in LD 17.
3 Within about 30 seconds, the D-channel layer 3 should be
established. To confirm, enter the following command in LD 60 to
request the current status of the D-channel:
STAT DCH (N)
The system response is:
DCH N EST OPER
This means that the D-channel is established and operational.
—End—
The DCHI and DTI cards must be implemented prior to software enabling
the NTAK09. Refer to the section
Procedure 33 "Implementing basic PRI"
(page 212) for further information.
Procedure 35
Enabling the NTAK09 card
Step Action
1 Enter the following command in LD 60 to software enable all NTAK09
DTI/PRI cards:
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301 02.03 Standard
Release 5.5 7 December 2007
Copyright © 2003-2007, Nortel Networks
.