Table 106 configuring basic isl capability – Nortel Networks NN43001-301 User Manual
Page 289

ISL software implementation
289
Dedicated mode
The DCHI uses the NTAK02 circuit card and does not support ISDN PRI
signaling. The DCHI is reserved for ISL use only. The D-channel can
communicate with the far-end by means of a dedicated leased line modem
or dialup modem.
Note that the following implementation relates to analogue TIE trunks being
used as B-channels. In the case where DTI/PRI trunks are also used, then
LD 17 digital loop (2.0 Mb PRI) and LD73 (2.0 Mb PRI/SYTI) must also be
configured with the appropriate clocking and threshold settings.
For ISL dedicated mode using a dialup modem, a 500 set, TIE trunk
route and member must be programmed (used for D-channel).
"Configuring basic ISL capability" (page 289)
summarizes the required
steps.
Table 106
Configuring basic ISL capability
Step
LD
Action
1
17
Configure the D-channel for ISL use.
2
15
Enable ISDN option.
3
16
Enable the ISL option on a per route basis, assign a D-channel
for each route.
4
14
Assign a channel identification to each trunk with the ISL
option.
LD 17 - Configure the D-channel for ISL
Prompt
Response
Description
REQ
CHG
Change existing data
TYPE
CFN
Configuration data block.
ADAN
NEW DCH 0-79
Add primary D-channel.
CTYP
DCHI
D-channel card type.
CDNO
0-15
1-9 11-19 21-29,
31-39 41-49
1-50
Serial Data Interface (SDI) Card number.
Number the SDI cards logically with the
system.
MSDL application small system Card
number
DCHI small system Card number
PORT
1
Must be set to 1.
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301
02.03
Standard
Release 5.5
7 December 2007
Copyright © 2003-2007, Nortel Networks
.