Nortel Networks NN43001-301 - Manual (Page 242)

242 2.0 Mb DTI implementation
Task summary list
The following is a summary of the tasks in this section:
1. "LD 17 - Adding a 2.0 Mb DTI card" (page 242)
2. "LD 73 - Defining the 2.0 Mb DTI ABCD signaling bit tables" (page 242)
3. "LD 73 - Defining the 2.0 Mb DTI pad tables" (page 246)
4. "LD 73 - Defining the 2.0 Mb DTI timers" (page 249)
5. "LD 73 - Defining the 2.0 Mb DTI system timers" (page 252)
6. "LD 16 - Configuring the service routes" (page 253)
LD 17 - Adding a 2.0 Mb DTI card
Prompt Response Description
REQ CHG Change.
TYPE CEQU Common equipment.
...
DTI2 xx Enter a card slot number for 2.0 Mb DTI.
LD 73 - Defining the 2.0 Mb DTI ABCD signaling bit tables
Prompt Response Description
REQ NEW
CHG Add or change Digital Trunk Interface data block.
TYPE DTI2 2.0 Mb/s DTI data block.
FEAT ABCD ABCD bit signaling category.
SICA 2-16 Signaling category.
...
DFLT (1)-16 Default signaling category used for default values
JDMI defaults to 16 with 3 .
Incoming/Outgoing Calls:
IDLE(S) abcd (Send) idle signal bits.
IDLE(R) abcd (Receive) idle signal bits.
FALT(S) abcd (Send) bits. 2.0 Mb DTI out-of-service.
N If FALT (send) signal not required.
FALT(R) abcd (Receive) bits. 2.0 Mb DTI out-of-service.
N If FALT (receive) signal not required.
Incoming Calls:
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301 02.03 Standard
Release 5.5 7 December 2007
Copyright © 2003-2007, Nortel Networks
.