Nortel Networks NN43001-301 - Manual (Page 117)

Cable requirements 117
Cable From Des. Con. To Des. Con. Notes
QCAD133 PRI card J4 Patch Panel 7
RS-232 PRI card J6 Echo Cance
ller 7
Note 1: Only when primary clock source.
Note 2: Only when secondary clock source.
Note 3: multigroup junctor board connection.
Note 4: Run to connector on network pack.
Note 5: Run directly to DCHI card.
Note 6: Run by means of cabinet I/O panel to CSU, echo canceller, or cross connect terminal.
Note 7: Run by means of cabinet I/O panel to crossconnect terminal or echo canceller from non
shielded system.
Note 8: No additional cabling is required for multiple PRIs. The D-channel is associated through
software in LD17, prompt PRI.
Table 31
Cable for the QPC720 PRI card for Half and Multi Group systems
Cable From Des. Con. To Des. Con. Comments
For half group only
QCAD130
NT8D79xx QPC720 J1 QPC471/
QPC775 CC-0 J2 Only when
primary clock
source.
QCAD130
NT8D79xx QPC720 J1 QPC471/
QPC775 CC-0 J1 Only when
secondary clock
source.
NTND26 QPC720 J5 NT6D80
For single group only
QCAD130
NT8D79xx QPC720 J2 QPC471/
QPC775 CC-1 J2 Only when
primary clock
source.
QCAD130
NT8D79xx QPC720 J2 QPC471/
QPC775 CC-1 J1 Only when
secondary clock
source.
QCAD125
NT8D75xx QPC471/
QPC775 CC-0 J3 QPC471/
QPC775 CC-1 J3 Clock controller
back-up.
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301 02.03 Standard
Release 5.5 7 December 2007
Copyright © 2003-2007, Nortel Networks
.