Nortel Networks NN43001-301 - Manual (Page 79)

79
DCH installation
Contents
The section contains information on the following topics:
"Install the NT6D11AB, NT6D11AE, NT6D11AF DCH" (page 79)
"Install the NT6D11AB, NT6D11AE, NT6D11AF DCH" (page 79)
"Set up the NT6D11AB, NT6D11AE, NT6D11AF DCHI" (page 80)
"DIP switch settings" (page 80)
"Protocol selection" (page 80)
"Valid switch combinations" (page 81)
"Jumper settings" (page 82)
"Port addressing modes" (page 83)
"Port address switch settings" (page 84)
"Install the NT6D11AB, NT6D11AE, NT6D11AF DCHI" (page 85)
"Remove the NT6D11AB, NT6D11AE, NT6D11AF DCH" (page 86)
"Install the QPC757 DCH" (page 87)
"Port address switch settings" (page 89)
"D-channel parameter downloading" (page 90)
"Remove the QPC757 DCHI" (page 90)
Install the NT6D11AB, NT6D11AE, NT6D11AF DCH
Installation procedures for the NT6D11AB, NT6D11AE, and NT6D11AE
DCHI cards are the same for all Large Systems. These instructions apply to
hardware both for primary and backup D-channels. D-channel lines must be
conditioned for 64K before D-channels can be brought up.
Note: To configure J1, the asynchronous port on the DCHI card, refer
to the documentation of the application being interfaced, and to Circuit
Card Reference (NN43001-311). J1 configuration is not described in
this technical document.
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301 02.03 Standard
Release 5.5 7 December 2007
Copyright © 2003-2007, Nortel Networks
.