Procedure 36 implementing dti, Procedure 36, Implementing dti – Nortel Networks NN43001-301 User Manual
Page 223

Software enable the DTI/PRI cards
223
ENLL C
where
C
is the DTI/PRI card number (DLOP). The card number
associated with a DTI/PRI card is based on the slot in which the
card is installed.
Under normal conditions, this step enables the clock controller and
D-channel interface. If enable fails, go to step 2.
2
Optional: Enter the following command in LD 60 to enable clock
tracking on the primary digital card:
ENL CC 0
3
Enter the following command in LD 96 to software enable the
NTAK93 (DCHI) daughterboard:
ENL DCHI N
where
N
is the DCHI I/O address.
4
Within about 30 seconds, the D-channel layer 3 should be
established. To confirm, enter the following command in LD 60 to
request the current status of the D-channel:
STAT DCH (N)
The system response is:
DCH N EST OPER
This means that the D-channel is established and operational.
—End—
Use this procedure to implement the DTI software interface between
systems or between a system and a central office.
Procedure 36
Implementing DTI
Step
Action
1
Add a DTI card. See
"LD 17 - Adding a DTI card" (page 224)
2
Configure a DTI trunk route. See
"LD 16 - Configuring a DTI trunk
.
3
Configure the trunks. See
"LD 14 - Configuring the trunks" (page
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301
02.03
Standard
Release 5.5
7 December 2007
Copyright © 2003-2007, Nortel Networks
.