ATL Telecom R1-SW Ethernet Switch - Manual (Page 147)

Configuring SNMP and RMON
8-13
Displaying SNMP Information
The section describes how to display SNMP configuration information, SNMP community
strings, SNMP trap hosts, and SNMP statistics.
Displying SNMP Configuration Information
To display SNMP configuration information, use the show snmp-server command in
Privileged mode.
The following example is a sample output of the show snmp-server command:
# show snmp-server
RMON: Enabled
Extended RMON: Extended RMON module is not present
sysContact Dial System Administrator at phone #2734
sysLocation 1st_floor lab
Community-Access Community-String
---------------- ----------------
read-write R1SW24
Trap-Rec-Address Version Trap-Rec-Community
---------------------------- ------- ----------------------
udp:172.168.2.23:162 v2c R1SW24
Traps Enabled
------------------------- ------------------
chassis disabled
module disabled
port enabled
bridge disabled
repeater disabled
ip_permit disabled
sysconfig disabled
entity disabled
cpuload disabled
auth enabled
sysauth disabled
bgp disabled
dhcp disabled
atm disabled
adslAtuc enabled
adslAtur disabled
mac-flood disabled
#