ATL Telecom R1-SW Ethernet Switch - Manual (Page 101)

Basic Configuration
5-33
The following is a sample output from the show ip route command:
# show ip route
Codes: K - kernel route, C - connected, S - static, R - RIP, O - OSPF,
I - IS-IS, B - BGP, > - selected route, * - FIB route, p - stale info
S> * default [1/0] via 172.19.1.254, management
B> * 100.100.10.0/24 [20/0] via 172.19.3.153, management, 1d20h55m
B> * 100.100.11.0/24 [20/0] via 172.19.3.153, management, 1d20h55m
B> * 100.100.14.0/24 [20/0] via 172.19.3.153, management, 1d20h55m
B> * 100.100.15.0/24 [20/0] via 172.19.3.153, management, 1d20h55m
C * 172.19.0.0/16 is directly connected, vlan1
C> * 172.19.0.0/16 is directly connected, management
Route Source Num of Entries
connected 2
static 1
bgp 4
Total 7
#