ATL Telecom R1-SW Ethernet Switch - Manual (Page 91)

Basic Configuration
5-23
interface management
ip address 172.27.68.100/16
!
ip route default 172.27.1.254
!
line vty 0 10
!
no ntp
!
#
Saving the Current Running Configuration
To save your configuration changes to NVRAM so that they will not be lost if the system is
rebooted, enter one of the following commands in Privileged command mode:
Table 5-13 Commands for saving the current running configuration
Command
Write memory
write file
copy running-config startup-config
The following example shows how to save the configuration changes to NVRAM using the
write memory
command:
# write memory
Building Configuration...
[OK]
#
The following example shows how to save the configuration changes to NVRAM using the
write file
command:
# write file
Building Configuration...
[OK]
#
The following example shows how to save the configuration changes to NVRAM using the
copy running-config startup-config
command:
# copy running-config startup-config