ATL Telecom R1-SW Ethernet Switch - Manual (Page 120)

R1-SW24L2B User’s Manual
6-8
Displaying Port Information
You can see the port configuration and port status using the show port command in the
Privileged mode. The following is a sample output from the show port command. This shows
the information about all ports on the Corecess R1-SW24L2B:
# show port
Port Name Status Vlan FlwCtl Duplex Speed Type
---- ------------- ---------- ----- ------- ------- -------- ----------
1/1 uplink-port connected 1 on full 1000 1000BasePON
1/2 DEFAULT notconnect 1 on full 1000 1000BaseSX
2/1 DEFAULT notconnect 1 a-off a-half a-0 100BaseT
2/2 DEFAULT notconnect 1 a-off a-half a-0 100BaseT
2/3 DEFAULT notconnect 1 a-off a-half a-0 100BaseT
2/4 DEFAULT notconnect 1 a-off a-half a-0 100BaseT
.
.
.
2/21 DEFAULT notconnect 1 a-off a-half a-0 100BaseT
2/22 DEFAULT notconnect 1 a-off a-half a-0 100BaseT
2/23 DEFAULT notconnect 1 a-off a-half a-0 100BaseT
2/24 DEFAULT notconnect 1 a-off a-half a-0 100BaseT
#
The table below describes the fields shown by the show port command:
Table 6-2 show port field descriptions
Field Description
Port Slot number/port number.
Name Port name.
Status
Port admin status and network connection
status.
Vlan Id of the VLAN which the port belongs to.
FlwCtrl Status of the flow control.
Duplex Duplex mode.
Speed Port speed.
Type Port type.