ATL Telecom R1-SW Ethernet Switch - Manual (Page 105)

Basic Configuration
5-37
Specifying Screen to Display Log
When an event is occurred, the information of the event can be appeared on the remote host
screen, a console screen, and telnet sessions.
Configuring to Display Log Messages on the Console Screen
To configure the log messages to display on the console screen, use the following commands in
Global configuration mode:
Table 5-23 Configuring log messages to display on the console
Command Task
logging console {enable |
disable }
1. Configure whether to display log messages on the console.
y enable: Displays log messages on the console.
y disable: Doesn’t display log messages on the console.
end 2. Return to Privileged mode.
show logging 3. Check the result.
write memory 4. Save the changed configuration.
The following example configures the log messages to display on the console screen and check
the result:
(config)# logging console enable
(config)# end
# show logging
console logging is enable
logging buffer is enable
logging file is disable
logging buffer size is 128 kbytes
.
.
# write memory
Building Configuration...
[OK]
#