Yaskawa SMC–4000 - Manual (Page 368)

358
SMC–4000 User Manual
The following is the #LIMSWI special label for handling situations where limit switches ar hit during
motion. This label automatically executes if an axis is in motion and a limit switch in the direction of
motion is hit, or a software limit is exceeded. Without this special label, if a limit switch is hit during
motion, such as a position absolute move, the motor will decelerate to a stop with NO ERROR. if an AM
command is used, it will be cleared. The example as shown does not recover from the limit switch error,
but a recovery method that woks well is the use of a status flag variable. For example if the machine was
in a manual jog operation, a variable could be used to indicate that it was in jog mode (JOGMODE=1).
The first line in the #LIMSWI could jump to #PROBLEM if JOGMODE <>1, otherwise return from the
error. The two commented lines below demonstrate this. (The JOGMODE variable can be set to “1” in the
jog routine and set back to “0” at the end of the jog routine.)
Instruction
Limit= “+”
Axis=”X”; JS #HARD,_LFX=0; JS#SOFT,_FLX<_TPX
Axis=”Y”; JS #HARD,_LFY=0; JS#SOFT,_FLY<_TPY
Limit=“-”
Axis=“X”; JS#HARD,_LRX=0; JS#SOFT, _BLX>_TPX
Axis=“Y”; JS#HARD,_LRY=0; JS#SOFT, _BLY>_TPY
(JP#PROBLEM,JOGMODE=0;REI)
(#PROBLEM)
AB1; HX1; HX2; HX3
ZS
MG “PROGRAM HALTED! (LIMSWI)”
EN
#HARD;MG Limit {S}, “,Axis,“HARDWARE LIMIT HIT!”;EN
#SOFT;MG Limit {S}, “,Axis,“SOFTWARE LIMIT HIT!”;EN