Yaskawa SMC–4000 - Manual (Page 329)

319
SMC–4000 User Manual
If the position error on the X axis exceeds that specified by the ER command, the #POSERR routine will
execute.
*Note The RE command is used to return from the #POSERR subroutine
*Note The #POSERR routine will continue to be executed until the position error is cleared (is
less than the ER limit).
Input Interrupt Example:
*Note Use the RI command to return from #ININT subroutine.
JP #LOOP;EN Loop
#POSERR Position Error Routine
V1=_TEX Read Position Error
MG "EXCESS POSITION ERROR" Print Message
MG "ERROR=",V1= Print Error
RE Return from Error
:XQ #LOOP Execute Dummy Program
:JG 100000 Jog at High Speed
:BGX Begin Motion
#A Label
II1 Input Interrupt on 1
JG 30000,,,60000 Jog
BGXW Begin Motion
#LOOP;JP#LOOP;EN Loop
#ININT Input Interrupt
ST;AM Stop Motion
#TEST;JP #TEST, @IN[1]=0 Test for Input 1 still low
BGXW;RI Begin motion and Return to Main Program
EN