H3C Technologies H3C WX3000 Series Unified Switches - Manual (Page 89)

11-8
Figure 11-2 Network diagram for protocol-based VLAN configuration
VLAN 100
IP Server
VLAN 200
Appletalk Server
Work room
GEth1/0/10
GEth1/0/12 GEth1 /0/11
IP Host Appletalk Host
Configuration procedure
# Create VLAN 100 and VLAN 200, and add GigabitEthernet 1/0/11 and GigabitEthernet 1/0/12 to
VLAN 100 and VLAN 200 respectively.
system-view
[device] vlan 100
[device-vlan100] port GigabitEthernet 1/0/11
[device-vlan100] quit
[device] vlan 200
[device-vlan200] port GigabitEthernet 1/0/12
# Configure protocol templates for VLAN 200 and VLAN 100, matching AppleTalk protocol and IP
protocol respectively.
[device-vlan200] protocol-vlan at
[device-vlan200] quit
[device] vlan 100
[device-vlan100] protocol-vlan ip
# To ensure the normal operation of IP network, you need to configure a user-defined protocol template
for VLAN 100 to match the ARP protocol (assume Ethernet II encapsulation is adopted here).
[device-vlan100] protocol-vlan mode ethernetii etype 0806
# Display the created protocol-based VLANs and the protocol templates.
[device-vlan100] display protocol-vlan vlan all
VLAN ID: 100
VLAN Type: Protocol-based VLAN
Protocol Index Protocol Type
0 ip
1 ethernetii etype 0x0806
VLAN ID: 200
VLAN Type: Protocol-based VLAN
Protocol Index Protocol Type
0 at