H3C Technologies H3C WX3000 Series Unified Switches - Manual (Page 379)

38-2
QoS Profile Configuration
QoS Profile Configuration Task List
Complete the following tasks to configure a QoS profile:
Task Remarks
Configuring a QoS Profile Required
Applying a QoS Profile Optional
Applying a QoS Profile Optional
Configuring a QoS Profile
Configuration prerequisites
z
The ACL rules used for traffic classification are defined. Refer to ACL in H3C WX3000 Series
Unified Switches Switching Engine Configuration Guide for information about defining ACL rules.
z
The type and number of actions in the QoS profile are specified.
Configuration procedure
Follow these steps to configure a QoS profile:
To do… Use the command… Remarks
Enter system view system-view —
Create a QoS profile and enter
QoS profile view
qos-profile profile-name —
Configure traffic policing
traffic-limit inbound acl-rule target-rate
[ conform con-action ] [ exceed
exceed-action
] [ meter-statistic ]
Optional
Configure packet filtering packet-filter inbound acl-rule
Optional
Refer to ACL in H3C WX3000
Series Unified Switches
Switching Engine Configuration
Guide
for information about
packet filtering.
Configure priority marking
traffic-priority inbound acl-rule { dscp
dscp-value | cos cos-value }
Optional
Applying a QoS Profile
You can configure to apply a QoS profile dynamically or simply apply a QoS profile manually.
Configuration prerequisites
z
To configure to apply a QoS profile dynamically, make sure 802.1x is enabled both globally and on
the port, and the authentication mode is determined. For information about 802.1x, refer to 802.1x
and System Guard in H3C WX3000 Series Unified Switches Switching Engine Configuration
Guide .
z
To apply a QoS profile manually, make sure the port to which the QoS profile is to be applied is
determined.