H3C Technologies H3C WX3000 Series Unified Switches - Manual (Page 58)

1-4
Web-based network management system after passing the authentication. If no login banner is
configured by the header command, a user logging in through Web directly enters the user login
authentication page.
Follow these steps to configure the login banner:
To do… Use the command… Remarks
Enter system view system-view —
Configure the banner to be displayed
when a user logs in through Web
header login text
Required
By default, no login banner is
configured.
Configuration Example
Network requirements
As shown in Figure 5-4 ,
z
A user logs in to the switching engine through Web.
z
The banner page is desired when a user logs in to the switching engine.
Figure 5-4 Network diagram for login banner configuration
Configuration Procedure
# Enter system view.
system-view
# Configure the banner "Welcome" to be displayed when a user logs in to the switching engine through
Web.
[device] header login %Welcome%
Assume that a route is available between the user terminal (the PC) and the switching engine. After the
above-mentioned configuration, if you enter the IP address of the switching engine in the address bar of
the browser running on the user terminal and press , the browser will display the banner page,
as shown in
Figure 5-5 .