H3C Technologies H3C WX3000 Series Unified Switches - Manual (Page 376)

37-32
To do… Use the command… Remarks
Display traffic redirecting configuration of a
port or all the ports
display qos-interface { interface-type
interface-number | unit-id }
traffic-redirect
Display traffic accounting configuration of a
port or all the ports
display qos-interface { interface-type
interface-number | unit-id }
traffic-statistic
Display VLAN mapping configuration of a port
or all the ports
display qos-interface { interface-type
interface-number | unit-id }
traffic-remark-vlanid
Display traffic mirroring configuration of a port
or all the ports display qos-interface { interface-type
interface-number | unit-id } mirrored-to
Display the configuration of traffic mirroring,
traffic policing, priority marking, traffic
redirecting, or traffic accounting performed for
all the packets
display qos-global { all | mirrored-to |
traffic-limit | traffic-priority |
traffic-redirect | traffic-statistic }
Display the configuration of traffic mirroring,
traffic policing, priority marking, traffic
redirecting, or traffic accounting performed for
packets of a VLAN display qos-vlan [ vlan-id ] { all |
mirrored-to | traffic-limit |
traffic-priority | traffic-redirect |
traffic-statistic }
Display the configuration of traffic mirroring,
traffic policing, priority marking, traffic
redirecting, or traffic accounting performed for
packets of a port group display qos-port-group [ group-id ] { all
| mirrored-to | traffic-limit |
traffic-priority
| traffic-redirect |
traffic-statistic }
QoS Configuration Example
Configuration Example of Traffic Policing
Network requirement
As shown in Figure 37-9 , an enterprise network connects all the departments through a device. PC1,
with the IP address 192.168.0.1 belongs to the R&D department and is connected to GigabitEthernet
1/0/1 of the switch. The marketing department is connected to GigabitEthernet 1/0/2 of the switch.
Configure traffic policing to satisfy the following requirements:
z
Set the maximum rate of outbound IP packets sourced from the marketing department to 64 kbps.
Drop the packets exceeding the rate limit.
z
Set the maximum rate of outbound IP packets sourced from the R&D department to 128 kbps. Drop
the packets exceeding the rate limit.
Figure 37-9 Network diagram for traffic policing and rate limiting configuration
The R&D
department
Switch
To the router
GEth1/0/1 GEth1/0/2
VLAN 1
The
marketing
department
VLAN 2
192.168.1.0/24 192.168.2.0/24