H3C Technologies H3C WX3000 Series Unified Switches - Manual (Page 595)

58-16
HWPing Configuration Example
ICMP Test
Network requirements
As shown in Figure 58-2 , Switch A serves as the HWPing client. A HWPing ICMP test between Switch A
and Switch B uses ICMP to test the round trip time (RTT) for packets generated by the HWPing client to
travel to and back from the destination.
Figure 58-2 Network diagram for the ICMP test
Switch A
Switch B
HWPing Client
IP network
10.1.1.1/8 10.2.2.2/8
Configuration procedure
z
Configure HWPing Client (Switch A):
# Enable HWPing client.
system-view
[device] hwping-agent enable
# Create a HWPing test group, setting the administrator name to "administrator" and test tag to "ICMP".
[device] hwping administrator icmp
# Configure the test type as icmp.
[device-hwping-administrator-icmp] test-type icmp
# Configure the destination IP address as 10.2.2.2.
[device-hwping-administrator-icmp] destination-ip 10.2.2.2
# Configure to make 10 probes per test.
[device-hwping-administrator-icmp] count 10
# Set the probe timeout time to 5 seconds.
[device-hwping-administrator-icmp] timeout 5
# Start the test.
[device-hwping-administrator-icmp] test-enable
# Set the maximum number of history records that can be saved to 5.
[device-hwping-administrator-icmp] history-records 5
# Display test results.
[device-hwping-administrator-icmp] display hwping results administrator icmp
HWPing entry(admin administrator, tag icmp) test result:
Destination ip address:10.2.2.2
Send operation times: 10 Receive response times: 10
Min/Max/Average Round Trip Time: 3/6/3
Square-Sum of Round Trip Time: 145
Last succeeded test time: 2000-4-2 20:55:12.3
Extend result:
SD Maximal delay: 0 DS Maximal delay: 0
Packet lost in test: 0%
Disconnect operation number: 0 Operation timeout number: 0
System busy operation number: 0 Connection fail number: 0