H3C Technologies H3C WX3000 Series Unified Switches - Manual (Page 550)

51-14
Figure 51-1 Network diagram for log output to a Unix log host
Internet
PC Switch
Configuration procedure
1) Configure Switch:
# Enable the information center.
system-view
[Switch] info-center enable
# Disable the function of outputting information to log host channels.
[Switch] undo info-center source default channel loghost
# Configure the host whose IP address is 202.38.1.10 as the log host. Permit ARP and IP modules to
output information with severity level higher than informational to the log host.
[Switch] info-center loghost 202.38.1.10 facility local4
[Switch] info-center source arp channel loghost log level informational debug state off trap
state off
[Switch] info-center source ip channel loghost log level informational debug state off trap
state off
2) Configure the log host:
The operations here are performed on SunOS 4.0. The operations on other manufacturers' Unix
operation systems are similar.
Step 1: Execute the following commands as the super user (root user).
# mkdir /var/log/Switch
# touch /var/log/Switch/information
Step 2: Edit the file “/etc/syslog.conf” as the super user (root user) to add the following selector/action
pairs.
# Switch configuration messages
local4.info /var/log/Switch/information
When you edit the file “/etc/syslog.conf”, note that:
z
A note must start in a new line, starting with a “#” sign.
z
In each pair, a tab should be used as a separator instead of a space.
z
No space is allowed at the end of a file name.
z
The device name (facility) and received log information severity level specified in the file
“/etc/syslog.conf” must be the same as those corresponding parameters configured in the
commands info-center loghost and info-center source. Otherwise, log information may not be
output to the log host normally.