H3C Technologies H3C WX3000 Series Unified Switches - Manual (Page 121)

15-6
To do… Use the command… Remarks
Enable flow control on the Ethernet
port
flow-control
Required
By default, flow control is not
enabled on a port.
Configuring Access Port Attribute
Follow these steps to configure access port attribute:
To do… Use the command… Remarks
Enter system view system-view —
Enter Ethernet port view
interface interface-type
interface-number
—
Configure the link type for the port
as access
port link-type access
By default, the link type for the port
is access.
Add the current access port into
the specified VLAN
port access vlan vlan-id Optional
Configuring Hybrid Port Attribute
Follow these steps to configure hybrid port attribute:
To do… Use the command… Remarks
Enter system view system-view —
Enter Ethernet port view
interface interface-type
interface-number
—
Set the link type for the port
as hybrid
port link-type hybrid Required
Set the default VLAN ID for
the hybrid port
port hybrid pvid vlan vlan-id
Optional
By default, the VLAN of a hybrid port is
VLAN 1.
Add the current hybrid port
into the specified VLAN port hybrid vlan vlan-id-list
{ tagged | untagged }
Optional
For a hybrid port, you can configure to
tag the packets of specific VLANs,
based on which the packets of those
VLANs can be processed in differently
ways.
Configuring Trunk Port Attribute
Follow these steps to configure trunk port attribute:
To do… Use the command… Remarks
Enter system view System-view —
Enter Ethernet port view
interface interface-type
interface-number
—