H3C Technologies H3C WX3000 Series Unified Switches - Manual (Page 114)

14-8
[SwitchA-GigabitEthernet1/0/3] gvrp
[SwitchA-GigabitEthernet1/0/3] quit
2) Configure Switch B
# The configuration procedure of Switch B is similar to that of Switch A and is thus omitted.
3) Configure Switch C
# Enable GVRP on Switch C, which is similar to that of Switch A and is thus omitted.
# Create VLAN 5.
[SwitchC] vlan 5
[SwitchC-vlan5] quit
4) Configure Switch D
# Enable GVRP on Switch D, which is similar to that of Switch A and is thus omitted.
# Create VLAN 8.
[SwitchD] vlan 8
[SwitchD-vlan8] quit
5) Configure Switch E
# Enable GVRP on Switch E, which is similar to that of Switch A and is thus omitted.
# Create VLAN 5 and VLAN 7.
[SwitchE] vlan 5
[SwitchE-vlan5] quit
[SwitchE] vlan 7
[SwitchE-vlan7] quit
6) Display the VLAN information dynamically registered on Switch A, Switch B, and Switch E.
# Display the VLAN information dynamically registered on Switch A.
[SwitchA] display vlan dynamic
Total 3 dynamic VLAN exist(s).
The following dynamic VLANs exist:
5, 7, 8,
# Display the VLAN information dynamically registered on Switch B.
[SwitchB] display vlan dynamic
Total 3 dynamic VLAN exist(s).
The following dynamic VLANs exist:
5, 7, 8,
# Display the VLAN information dynamically registered on Switch E.
[SwitchE] display vlan dynamic
Total 1 dynamic VLAN exist(s).
The following dynamic VLANs exist:
8
7) Configure GigabitEthernet 1/0/1 on Switch E to operate in fixed GVRP registration mode and
display the VLAN information dynamically registered on Switch A, Switch B, and Switch E.
# Configure GigabitEthernet 1/0/1 on Switch E to operate in fixed GVRP registration mode.
[SwitchE] interface GigabitEthernet 1/0/1
[SwitchE-GigabitEthernet1/0/1] gvrp registration fixed
# Display the VLAN information dynamically registered on Switch A.
[SwitchA] display vlan dynamic
Total 3 dynamic VLAN exist(s).
The following dynamic VLANs exist: