H3C Technologies H3C WX3000 Series Unified Switches - Manual (Page 557)

52-4
D:\>cd update
D:\Update>ftp 192.168.0.51
Connected to 192.168.0.51.
220 FTP service ready.
User (192.168.0.51:(none)): test
331 Password required for test.
Password:
230 User logged in.
ftp>
Step 7: Use the put command to upload the file config.cfg to Switch.
C:\Documents and Settings\Administrator>d:
D:\>cd update
D:\Update>ftp 192.168.0.51
Connected to 192.168.0.51.
220 FTP service ready.
User (192.168.0.51:(none)): test
331 Password required for test.
Password:
230 User logged in.
ftp> put startup.cfg
200 Port command okay.
150 Opening ASCII mode data connection for /startup.cfg.
226 Transfer complete.
Step 8: Configure config.cfg as the main configuration file at next startup, and then restart Switch.
startup saved-configuration config.cfg main
Please wait........................................Done!
reboot
After Switch restarts, the file config.cfg is used as the main configuration file. It indicates that the
configuration file loading is finished.
z
The steps listed above are performed in the Windows operating system, if you use other FTP client
software, refer to the corresponding user guide before operation.
z
Only the configuration steps concerning loading are listed here. For detailed description on the
corresponding configuration commands, refer to FTP-SFTP-TFTP in H3C WX3000 Series Unified
Switches Switching Engine Configuration Guide .