H3C Technologies H3C WX3000 Series Unified Switches - Manual (Page 526)

49-13
For information about the startup saved-configuration command and how to specify the startup file
for the device, refer to System Maintenance and Debugging in H3C WX3000 Series Unified Switches
Switching Engine Configuration Guide .
SFTP Configuration
Complete the following tasks to configure SFTP:
Task Remarks
Enabling an SFTP server Required
Configuring connection idle time Optional
SFTP Configuration: The Device
Operating as an SFTP Server
Supported SFTP client software —
Basic configurations on an SFTP client —
SFTP Configuration: The Device
Operating as an SFTP Client
Specifying the source interface or source
IP address for an SFTP client
Optional
SFTP Configuration: The Device Operating as an SFTP Server
Enabling an SFTP server
Before enabling an SFTP server, you need to enable the SSH server function and specify the service
type of the SSH user as SFTP or all. For details, see the SSH server configuration part of SSH in H3C
WX3000 Series Unified Switches Switching Engine Configuration Guide .
Follow these steps to enable an SFTP server:
To do… Use the command… Remarks
Enter system view system-view —
Enable an SFTP server sftp server enable
Required
Disabled by default
Configuring connection idle time
After the idle time is configured, if the server does not receive service requests from a client within a
specified time period, it terminates the connection with the client, thus preventing a user from occupying
the connection for a long time without performing any operation.
Follow these steps to configure connection idle time:
To do… Use the command… Remarks
Enter system view system-view —
Configure the connection idle time
for the SFTP server
ftp timeout time-out-value
Optional
10 minutes by default