H3C Technologies H3C WX3000 Series Unified Switches - Manual (Page 636)

62-6
Displaying and Maintaining PoE Configuration
To do… Use the command… Remarks
Display the PoE status of a specific port
or all ports of the device display poe interface [ interface-type
interface-number ]
Display the PoE power information of a
specific port or all ports of the device display poe interface power
[ interface-type interface-number ]
Display the PSE parameters display poe powersupply
Available in any view
PoE Configuration Example
PoE Configuration Example
Networking requirements
As shown in Figure 62-1 , Switch A supports PoE, Switch B can be PoE powered.
z
The GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2 ports of Switch A are connected to Switch B
and an AP respectively; the GigabitEthernet 1/0/8 port is intended to be connected with an
important AP.
z
The PSE processing software of Switch A is first upgraded online. The remotely accessed PDs are
powered by Switch A.
z
The power consumption of the accessed AP is 2,500 mW, and the maximum power consumption
of Switch B is 12,000 mW.
z
It is required to guarantee the power feeding to the PDs connected to the GigabitEthernet 1/0/8 port
even when Switch A is under full load.
Figure 62-1 Network diagram for PoE
Switch A
Network
GE1/0/2
GE1/0/1 GE1 /0/8
Switch B AP AP
Configuration procedure
# Upgrade the PSE processing software online.
system-view
[SwitchA] poe update refresh 0290_021.s19
# Enable the PoE feature on GigabitEthernet 1/0/1, and set the PoE maximum output power of
GigabitEthernet 1/0/1 to 12,000 mW.
[SwitchA] interface GigabitEthernet 1/0/1