H3C Technologies H3C WX3000 Series Unified Switches - Manual (Page 198)

22-29
Task Remarks
Configuring the Timeout Time Factor Optional
Configuring the Maximum Transmitting Speed on the
Current Port Optional
The default value is recommended.
Configuring the Current Port as an Edge Port Optional
Configuring the Path Cost for a Port Optional
Configuring Port Priority Optional
Specifying Whether the Link Connected to a Port Is
Point-to-point Link
Optional
In a network containing devices with both GVRP and MSTP enabled, GVRP packets are forwarded
along the CIST. In this case, if you want to broadcast packets of a specific VLAN through GVRP, be
sure to map the VLAN to the CIST when configuring the MSTP VLAN mapping table (the CIST of a
network is spanning tree instance 0).
Configuration Prerequisites
The role (root, branch, or leaf) of each device in each spanning tree instance is determined.
Configuring the MST Region
Refer to Configuring an MST Region .
Configuring the Mode a Port Recognizes and Sends MSTP Packets
Refer to Configuring the Mode a Port Recognizes and Sends MSTP Packets .
Configuring the Timeout Time Factor
Refer to Configuring the Timeout Time Factor .
Configuring the Maximum Transmitting Speed on the Current Port
Refer to Configuring the Maximum Transmitting Speed on the Current Port .
Configuring a Port as an Edge Port
Refer to Configuring the Current Port as an Edge Port .
Configuring the Path Cost for a Port
The path cost parameter reflects the rate of the link connected to the port. For a port on an
MSTP-enabled device, the path cost may be different in different spanning tree instances. You can