Displaying and maintaining ethernet ports – H3C Technologies H3C WX3000 Series Unified Switches User Manual
Page 126
15-11
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter Ethernet port view
interface interface-type interface-number
—
Enable the system to test
connected cables
virtual-cable-test
Required
z
Optical port (including Combo optical port) does not support VCT (virtual-cable-test) function.
z
Combo electrical port supports VCT function only when it is in UP condition (using undo shutdown
command), normal Ethernet electrical port always supports this function.
Configuring the Interval to Perform Statistical Analysis on Port Traffic
By performing the following configuration, you can set the interval to perform statistical analysis on the
traffic of a port.
When you use the display interface interface-type interface-number command to display the
information of a port, the system performs statistical analysis on the traffic flow passing through the port
during the specified interval and displays the average rates in the interval. For example, if you set this
interval to 100 seconds, the displayed information is as follows:
Last 100 seconds input: 0 packets/sec 0 bytes/sec
Last 100 seconds output: 0 packets/sec 0 bytes/sec
Follow these steps to set the interval to perform statistical analysis on port traffic:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter Ethernet port view
interface interface-type
interface-number
—
Set the interval to perform statistical
analysis on port traffic
flow-interval interval
Optional
By default, this interval is 300
seconds.
Displaying and Maintaining Ethernet Ports
To do…
Use the command…
Remarks
Display port configuration
information
display
interface [ interface-type |
interface-type interface-number
]
Display information for a specified
port group
display port-group
group-id
Display port loopback detection
state
display loopback-detection
Available in any view