H3C Technologies H3C WX3000 Series Unified Switches - Manual (Page 60)

1-1
6
Logging In from NMS
Introduction
You can also log in to the switching engine from a network management station (NMS), and then
configure and manage the switching engine through the agent module on the switch. Simple network
management protocol (SNMP) is applied between the NMS and the agent. Refer to SNMP-RMON in
H3C WX3000 Series Unified Switches Switching Engine Configuration Guide for related information.
To log in to the switching engine from an NMS, you need to perform related configuration on both the
NMS and the switching engine.
Table 6-1 Requirements for logging in to the switching engine from an NMS
Item Requirement
The IP address of the VLAN interface of the switching engine is configured. The route
between the NMS and the switching engine is reachable. (Refer to IP Address and
Performance
and Routing Protocol in H3C WX3000 Series Unified Switches Switching
Engine Configuration Guide for related information.) Switching engine
The basic SNMP functions are configured. (Refer to SNMP-RMON in H3C WX3000
Series Unified Switches Switching Engine Configuration Guide
for related information.)
NMS
The NMS is properly configured. (Refer to the user manual of your NMS for related
information.)
Connection Establishment Using NMS
Figure 6-1 Network diagram for logging in from an NMS