H3C Technologies H3C WX3000 Series Unified Switches - Manual (Page 390)

39-8
Configuring MAC-Based Mirroring
z
The MAC address specified for MAC-based mirroring must be a static MAC address existing in the
MAC address table.
z
You can configure MAC-based mirroring for a remote source mirroring group to implement the
MAC-based remote mirroring function.
Configuration prerequisites
z
The MAC address to be matched is determined.
z
The destination port is determined.
Configuration procedure
Follow these steps to configure MAC-based mirroring:
To do… Use the command… Remarks
Enter system view system-view —
Create a local or remote source
mirroring group mirroring-group group-id
{ local | remote-source }
Required
Configuring MAC-Based Mirroring
mirroring-group group-id
mirroring-mac mac vlan
vlan-id
Required
Configure the destination port for
the mirroring group mirroring-group group-id
monitor-port monitor-port-id
Required
Note that you need not configure the
destination port on the source switch
when configuring MAC-based remote
mirroring.
Configuration example
Configure MAC-based mirroring to mirror packets whose source/destination MAC addresses match
000f-e20f-0101 to port GigabitEthernet 1/0/2 on the local device.
Configuration procedure:
system-view
[device] mac-address static 000f-e20f-0101 interface Gigabitethernet 1/0/1 vlan 2
[device] mirroring-group 1 local
[device] mirroring-group 1 mirroring-mac 000f-e20f-0101 vlan 2
[device] mirroring-group 1 monitor-port GigabitEthernet 1/0/2