H3C Technologies H3C WX3000 Series Unified Switches User Manual
Page 470
46-19
Figure 46-9
Network diagram for NTP multicast mode configuration
Vlan-int2
1.0.1.31/24
Vlan -int2
3.0.1.31/24
Vlan -int2
3.0.1.32/24
Device A
Device B
Device C
Device D
Configuration procedure
1) Configure Device C.
# Enter system view.
# Set Device C as a multicast server to send multicast messages through Vlan-interface2.
[DeviceC] interface Vlan-interface 2
[DeviceC-Vlan-interface2] ntp-service multicast-server
2) Configure Device A (perform the same configuration on Device D).
# Enter system view.
# Set Device A as a multicast client to listen to multicast messages through Vlan-interface2.
[DeviceA] interface Vlan-interface 2
[DeviceA-Vlan-interface2] ntp-service multicast-client
After the above configurations, Device A and Device D respectively listen to multicast messages
through their own Vlan-interface2, and Device C advertises multicast messages through
Vlan-interface2. Because Device A and Device C do not share the same network segment, Device A
cannot receive multicast messages from Device C, while Device D is synchronized to Device C after
receiving multicast messages from Device C.
View the NTP status of Device D after the clock synchronization.
[DeviceD] display ntp-service status
Clock status: synchronized
Clock stratum: 3
Reference clock ID: 3.0.1.31
Nominal frequency: 60.0002 Hz
Actual frequency: 60.0002 Hz
Clock precision: 2^18
Clock offset: 198.7425 ms
Root delay: 27.47 ms
Root dispersion: 208.39 ms
Peer dispersion: 9.63 ms
Reference time: 17:03:32.022 UTC Thu Sep 7 2006 (BF422AE4.05AEA86C)