H3C Technologies H3C WX3000 Series Unified Switches - Manual (Page 658)

66-8
To do... Use the command... Remarks
Enter RIP view rip —
Set the RIP timers
timers { update update-timer |
timeout timeout-timer } *
Required
By default, the Update timer is 30 seconds and
the Timeout timer 180 seconds.
When configuring the values of RIP timers, you should take network performance into consideration
and perform consistent configuration on all routers running RIP to avoid unnecessary network traffic
and network route oscillation.
Configuring split horizon
Follow these steps to configure split horizon:
To do... Use the command... Remarks
Enter system view system-view —
Enter interface view
interface interface-type
interface-number
—
Enable split horizon rip split-horizon
Required
Enabled by default
Split horizon cannot be disabled on a point-to-point link.
Configuring RIP-1 packet zero field check
Follow these steps to configure RIP-1 packet zero field check:
To do... Use the command... Remarks
Enter system view system-view —
Enter RIP view rip —
Enable the check of the must be zero field
in RIP-1 packets
checkzero
Required
Enabled by default
Some fields in a RIP-1 packet must be 0, and they are known as must be zero field. For RIP-1, the
must be zero field is checked for incoming packets, and those RIP-1 packets with this field being
nonzero will not be processed.